22 2Aspectos forenses das lesões ortopédicas nos atropelamentos 
Home Page  

  • SciELO

  • SciELO


Revista Portuguesa de Ortopedia e Traumatologia

 ISSN 1646-2122

DUARTE, Ricardo    RAMOS, António. Estudo comparativo da distribuição de carga articulação anca intacta e com prótese total press-fit e resurfacing. []. , 22, 2, pp.5-18. ISSN 1646-2122.

^lpt^aO estudo tem como objetivo a análise de comportamento de duas soluções de prótese total existentes para a articulação da anca a quando da existência de boa qualidade de osso. Foram desenvolvidos três modelos experimentais e computacionais, baseados em modelos sintéticos das estruturas ósseas. Um modelo considerando a articulação da anca intacta e dois com prótese total da anca. As soluções estudadas de prótese total envolveram uma prótese total press-fit e uma prótese de resurfacing. Foram desenvolvidos os modelos computacionais através do processo de digitalização 3D após implantação das soluções in vitro. Nos modelos computacionais foram aplicadas as respetivas condições experimentais dos modelos in vitro por forma a simular o caso real, considerando uma carga total na reação de 170Kg na articulação. Os resultados permitiram verificar uma aproximação do comportamento mecânico da articulação com prótese de Birmingham® de resurfacing e articulação intacta. Contudo, observaram-se zonas com probabilidade de possível falha do osso por fadiga com elevadas deformações. O aspeto medial do fémur apresenta-se como o mais crítico apresentado as mais elevadas deformações. As duas soluções de artroplastia estudadas apresentam distribuição semelhante na estrutura Ilíaca, verificando-se que ambas as soluções apresentam diminuição da deformação o que promove a perda óssea na zona acetabular. Os resultados revelam que ambas as soluções modificam a distribuição de carga na estrutura óssea, contudo a solução resurfacing apresenta comportamento mais próximo da articulação intacta. Os resultados da deformação revelam alteração da distribuição de carga e da reação nos modelos com prótese, apresentando distribuição distal diferenciadora.^len^aThe study aims to analyze the behavior of two different total hip replacement solutions when there is good bone quality. Three experimental and computational models based on synthetic hip joint models were developed. The models consider the intact joint and two others with total hip replacement. The solutions studied involve a total press-fit and a resurfacing prosthesis. Each model of the hip joint was developed computationally through the process of 3D scanning after implementation solutions. The computational models were generated based on 3D models and applied the respective experimental conditions for each of the models, as the same experimental conditions, considering a load in the reaction of 170Kg applied on the Iliac. Results indicate an approximation of the mechanical behavior of the intact hip joint prosthesis with Birmingham ® resurfacing. However there were areas where it is possible a fatigue failure at high deformations. The medial aspect of the femur presented as the most critical with high deformations. Total arthoplasty solutions studied showed similar distribution in iliac bone; however both decrease the deformation which promotes bone loss in the acetabulum region. The results show that both solutions modify the load distribution in the bone structure, however, the resurfacing solution has the closest behavior of the intact joint. The results reveal that the deformation changes the load distribution and reaction models with prosthesis, due to different distal distribution.

: .

        · | |     ·     · ( pdf )

 

Creative Commons License All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License