32 2 
Home Page  

  • SciELO

  • SciELO


Revista de Ciências Agrárias

 ISSN 0871-018X

MENDES, Rafael Farinassi et al. The adhesive effect on the properties of particleboards made from sugar cane bagasse generated in the distiller. []. , 32, 2, pp.209-218. ISSN 0871-018X.

^len^aThe objective was to evaluate the effect of the adhesive type and its different contents on sugar cane bagasse particleboards. The panels were produced using Urea-Formaldehyde (UF) and Phenol-Formaldehyde (PF) adhesives. Three adhesive contents were tested: 6, 9 and 12%. The boards were made by using an 8-minute press closing time, pressure of 40kgf/cm², and temperature of 160ºC for the UF adhesive and 180ºC for the PF adhesive. It was concluded that: The UF adhesive was statistically equal or better than PF adhesive considering all properties evaluated. The adhesive contents of 9 and 12% were statistically equal, but both were superior to 6% considering the physical properties. The mechanical properties did not present statistical differences, except for rupture modulus. The best panels were produced using UF at 9%, but they did not attend the norm CS 236-66 for mechanical properties, therefore it is necessary manipulations of the processing variables.^lpt^aO objetivo foi avaliar o efeito do tipo de adesivo e de seus diferentes teores na produção de painéis aglomerados com bagaço de cana. Os painéis foram produzidos utilizando os adesivos Uréia-Formaldeido (UF) e Fenol-Formaldeido (FF) a 6, 9 e 12%. O ciclo de prensagem utilizado foi de 40kgf/cm², temperatura de 160ºC para UF e 180ºC para FF, por 8 minutos. Concluiu-se que: O adesivo UF se mostrou estatisticamente igual ou superior a FF em todas as propriedades avaliadas. Para os teores de adesivo, nas propriedades físicas, os teores 9 e 12% se mostraram estatisticamente iguais, mas superiores a 6%; já nas propriedades mecânicas não houve diferença estatística, com exceção do módulo de ruptura. Os melhores painéis foram produzidos com UF e 9% de teor de adesivo, sendo que estes não atenderam a norma CS 236-66 para propriedades mecânicas, sendo necessárias manipulações nas variáveis de processamento.

: .

        · | |     ·     · ( pdf )

 

Creative Commons License All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License