21 2Evaluation of Chromate as Dezincification Inhibitor for α-brass (Cu/Zn : 64/36) in 3% Chloride Buffer SolutionsElectrochemical Characterisation Study of Coatings Obtained by High Velocity Oxy-Fuel Spraying (HVOF) 
Home Page  

  • SciELO

  • SciELO


Portugaliae Electrochimica Acta

 ISSN 0872-1904

NOCE, R.D.; FUGIVARA, C.S.; BARELLI, N.    BENEDETTI, A.V.. Electrochemical Studies of Cu-Al Alloys in Sulphate Solutions with Different pH. []. , 21, 2, pp.117-139. ISSN 0872-1904.

The electrochemical behavior of Cu-(0.5-13 wt.%)Al alloys in K2SO4 0.5 mol dm-3 (m = 1.5 M, pH 2-5) was studied using open-circuit potential (Eoc) measurements and polarization curves, in order to know the conditions of copper oxides formation, influence of Al concentration and solution pH on the electrode processes. The open-circuit potential measurements with time indicated that the Eoc decreases with the Al content, due to the lower Al potential compared to Cu. The electrode potentials decrease ca. 20 mV per unity of solution pH as increase pH of the solution. The polarization curves showed changes with the increase of Al concentration. For alloys with up to 3 wt.%Al the obtained Tafel anodic coefficient was 40 mV/decade for low potentials region (E < -320 mV) and 130 mV/decade for the other region (-320 < E/mV < -250), indicating that up to this concentration there is no considerable change in the  electrochemical behavior of the alloys, when compared to pure Cu. For alloys with an Al content from 8 to 13 wt.% the Tafel anodic coefficient was 60 mV/decade. No influence of the solution pH on the Tafel anodic coefficient was observed.

: Cu-Al alloys; electrochemical oxidation.

        · |     · ( pdf )

 

Creative Commons License All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License